广东XXX科技有限公司

当前位置: 网站首页 > 仪器设备 > UL498插头插座仪器设备
UL498插头插座仪器设备

3磅1-15P插座保持力规

3磅1-15P插座保持力规
  • 型号 : AG1-15P
  • 品牌 : 广东安规
  • 标准依据 : UL498表93.1
3磅1-15P插座保持力规

详细描述

根据UL498要求,6个连接器应当按表93.1要求的插头连续插拔10次插入拔出无孔插脚后,按表93.1要求,一个重3磅(13N)力施加于垂直结合面对插头在保持一分钟后,位移不应当大于2mm。

根据表93.1要求,1-15R、5-15R、5-20R、应当使用1-15P插头测试。

 

93.3 Each of six devices is to be subjected to ten conditioning cycles of insertion and withdrawal of a standard solid-blade attachment plug that has American National Standard detent holes in accordance with Wiring Devices – Dimensional Specifications, ANSI/NEMA WD6, in rigidly mounted blades, following which the plug is to be fully reinserted into the device. The mating plugs are to have the configuration indicated in Table 93.1. A pull of 3 lbf (13 N) in a direction perpendicular to the plane of the face of the cord connector and tending to withdraw the plug from the device is then to be applied to the plug for 1 minute. The displacement of the plug shall not be greater than 0.079 inch (2 mm).
 
Table 93.1 Mating Plug configurations for plug retention
Device under test Mating plug No. of devices tested
1-15R 1-15P 6
5-15R 1-15P 6
5-20R

1-15P

5-20P(a)

3

3

6-15R 2-15P 6
6-20R

2-15P

6-20P(a)

3

3

a Shall have the ground blade removed.    

 

Exception: Connectors may instead be subjected to the Retention of Blades Test, Section 111.2 and 111.3 (conditioning and 3 lb retention).
点击次数:  更新时间:2018-05-03  【打印此页】  【关闭